Overview - Stabilizer Bar, With Sway Stabilization
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Stabilizer Bar with Sway Stabilization
- With Left Rear Suspension Stabilization Actuator -V636-
- With rubber bushing and clamp, refer to -item 16-
- The rubber bushing and clamp cannot be replaced individually
- When removing and installing, do not disconnect the wiring harness from the stabilizer bar with sway stabilization
- The connector may only be disconnected if a damaged wiring harness must be replaced.
- To ensure a proper seal, the connector on the stabilizer bar with sway stabilization may only be connected and tightened once. Tightening specification: 2 Nm
- Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, VERSIONS WITH SWAY STABILIZATION .
- Bolt
- 20 Nm
- Bracket
- For the wiring harness
- Metal Nut
- 2.5 Nm
- Heat Shield
- Bolt
- 6 Nm
- Nut
- 4 Nm
- Bracket
- For Sway Stabilization Control Module 2 -J1096-
- Subframe
- Nut
- Replace after removing
- Sway Stabilization Control Module 2 -J1096-
- Removing and Installing. Refer to Sway Stabilization Control Module 2 -J1096-, REMOVING AND INSTALLING .
- Nut
- Replace after removing
- Coupling Rod
- Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Bolt
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .
- 40 Nm + 180°
- Clamp
- No replacement part
- A component of the stabilizer bar, refer to -item 1-
- Bolt
- Replace after removing
- 25 Nm + 90°