Drivetrain Control Module -J775-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ7, 2022 Audi Q7, 2021 Audi SQ7, 2021 Audi Q7, and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Drivetrain Control Module -J775- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Remove the center console trim panels. Refer to OVERVIEW - CENTER CONSOLE .
-- Disconnect the connector -2-.
-- Remove the left and right nuts -arrows- and remove the Drivetrain Control Module -J775-.