Overview - Wheel Bearing
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Wheel Bearing Housing
- Removing and installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
- Bolt
- 80 Nm + 90°
- Replace after removing.
- Drive Axle
- Wheel Bearing
- Wheel Bearing Unit, Removing and installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Handling. Refer to Fig 2
- Wheel Hub
- Wheel hub lateral run-out while installed 0.02 mm (measured on the outer diameter of the wheel hub)
- Measure the lateral run-out with the Dial Indicator - 0-10mm: VAS6079 and Dial Indicator Bracket: VAS6079/1
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Bolt
- Replace after removing.
- Before installing, clean the threads in the CV joint with a thread tap.
- Drive Axle Threaded Connection, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
Wheel Bearing, Handling
CAUTION:
Improper handling and poor cleanliness could increases the risk of wheel bearing damage.
- Note the following instructions for handling the wheel bearing.
- Position the wheel bearing -1- so that it faces upward.
- Always set the wheel bearing down on the wheel hub -2-.