Stabilizer Bar, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Before starting work:

-- Versions with coil springs: determine the curb weight position. Refer to VEHICLES WITH COIL SPRINGS, CHECKING THE CURB WEIGHT POSITION FOR AXLE ALIGNMENT .

-- Versions with air suspension: determine the standard vehicle height. Refer to STANDARD VEHICLE HEIGHT FOR AXLE ALIGNMENT ON VEHICLES WITH AIR SUSPENSION, CHECKING .

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the left and right front wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Insert the left and right support braces : T40335 in the subframe. If required, adjust the support brace at the knurled handle -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Secure the support brace with securing pins -arrows-.

-- Remove the left and right nuts -arrows and 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right clamp -1- and bolt -4-.

-- Remove the stabilizer bar -2-.