Stabilizer Bar, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Strut: T40335
Strut: T40335 , Preparing
-- Measure the diameter of the hole in the subframe.
a - 17.6 mm
b - 15.6 mm
-- If necessary, loosen the set screw -1-.
-- Insert the Pin : T40335 on the correct side in the Strut: T40335 .
-- Tighten the set screw again.