Right SUBFRAME Shield, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the drive axle cover. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

Equipped on Some Models:

Fig 1: Identifying Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3-.

-- Remove the bolt -1- and move the level control system sensor to the side.

Continuation for All:

-- Loosen the front wheel housing liners in the front area. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Free up the wiring duct -4- on the right coolant pipe and on the subframe.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and bolt -3- and press the right coolant pipe up slightly on the subframe.

-- Loosen the threaded connections -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the shield -1- toward the right side.