Overview - SUBFRAME
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2022 Audi RS 7 Sportback, 2022 Audi A7 e Quattro, 2022 Audi A7 Quattro, 2021 Audi S7, and 2021 Audi RS 7 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 90 Nm +90°
- Replace after removing.
- Bolt
- 20 Nm + 90°
- Replace after removing.
- Bolt
- 20 Nm + 90°
- Replace after removing.
- Bracket
- For the wiring harness
- Bolt
- 9 Nm
- Bolt
- 115 Nm +90°
- Replace after removing.
- Tightening sequence. Refer to Fig 3.
- Right Subframe
- Securing. Refer to SUBFRAME, SECURING .
- Lowering. Refer to SUBFRAME, LOWERING .
- Removing and installing. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Shield
- Removing and installing. Refer to SUBFRAME SHIELD, REMOVING AND INSTALLING .
- Nut
- 9 Nm
- End Panel
- Bolt
- 50 Nm + 90°
- Replace after removing.
- Nut
- 30 Nm
- Replace after removing.
- Subframe Crossbrace
- Safety Precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING ON SUBFRAME .
- Removing and installing. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
- Bolt
- 115 Nm +90°
- Replace after removing.
- Tightening sequence. Refer to Fig 2.
- Bolt
- 70 Nm +45°
- Replace after removing.
- Bolt
- 70 Nm +90°
- Replace after removing.
Subframe Crossbrace - Tightening Sequence
-- Tighten the bolts in steps:
| Step | Bolts | Tightening Sequence |
|---|---|---|
| 1. | -arrows- | Install by hand all the way |
| 2. | -arrows- | Tighten diagonally in stages |
Subframe with Crossbrace - Tightening Sequence
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Sequence |
|---|---|---|
| 1. | -1 through 10- | Install by hand all the way |
| 2. | -1 through 10- | Tighten |