Overview - Bumper Cover, From Product Improvement
- Mount
- Center
- For the bumper cover
- Removing and Installing. Refer to CENTER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Nut
- Quantity: 6
- 4 Nm
- Mount
- Lower
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, BOTTOM .
- Nut
- Quantity: 4
- 3 Nm
- Bumper Cover Upper Section
- Removing and Installing. Refer to BUMPER COVER UPPER SECTION, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- 2.5 Nm
- Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .
- Spoiler
- Removing and Installing. Refer to SPOILER, REMOVING AND INSTALLING, FROM PRODUCT IMPROVEMENT .
- Bolt
- Quantity: 4
- 2.5 Nm
- Tail Pipe
- Equipped on some models
- Overview. Refer to the appropriate exhaust system article .
- Spring Nut
- Quantity: 8
- End Panel
- Equipped on some models
- Removing and Installing. Refer to END PANEL, REMOVING AND INSTALLING .
- Bolt
- Quantity: 8
- 4 Nm
- Bolt
- Quantity: 2
- 2.5 Nm
- Mount
- for lane change assistance control module
- Removing and Installing. Refer to SENSORS AND CONTROL MODULES
- Bolt
- Quantity: 4
- 2.5 Nm
- Mount
- Side
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING, SIDE .
- Bolt
- Quantity: 4
- Tightening sequence. Refer to Fig 2.
- Nut
- Quantity: 2
- 5 Nm
- Spring Nut
- Bracket
- For the tail pipe
- Equipped on some models
- Bracket
- For the Telephone Antenna -R65- / LTE Antennas 1 and 2 -R297/R306-
- Removing and installing. Refer to the appropriate service information. .
- Nut
- Quantity: 2
- Tightening specification. Refer to the appropriate service information .
Bumper Cover Side Mount - Tightening Specification and Sequence
-- Tighten the bolts in the sequence shown -1, 2, 4 and 3- to 3 Nm.