Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking, A7 SPORTBACK
Checking the Standard Vehicle Height for Axle Alignment
Before performing an axle alignment on a vehicle with air suspension, check the standard vehicle height and adapt it again if necessary.
-- Initiate and lock the standard vehicle height. Refer to STANDARD VEHICLE HEIGHT, INITIATING AND LOCKING .
Determine the Dimension -a-.
-- Determine dimension -a- between the center of the wheel and the lower edge of the fender/wheel housing as shown.
Dimension -a- Overview
| Suspension | Distance between the Center of the Wheel and the Lower Edge of the Fender/Wheel Housing | ||||||
|---|---|---|---|---|---|---|---|
| Front Axle | Rear Axle | Tolerance between the right and left | |||||
| Specified size. Refer to (1). | Tolerance | Specified size. Refer to (1). | Tolerance | ||||
| 1BK | 394 mm | ± 10 mm | 391 mm | ± 10 mm | Less than or equal to 10 mm | ||
|
|||||||
CAUTION:
Risk of faulty axle alignment.
- Never perform an axle alignment if the vehicle is not at standard vehicle height.
-- Initiate and lock the standard vehicle height. Refer to STANDARD VEHICLE HEIGHT, INITIATING AND LOCKING .