Rear Axle Camber, Adjusting
Special tools and workshop equipment required
- Fine tooth ratchet, commercially available
- 21 mm twelve-point socket, commercially available
Procedure
-- Remove the nut -1- from the subframe/rear lower transverse link threaded connection and install the new nut all the way.
-- Adjust the camber by rotating the adjusting bolt -2-.
TIP:
To turn the adjusting screw, turn the hex head at the >>top of the screw<<.
- Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
TIP:
- The maximum adjustment range is 135° to left or right of center position.
- Do not rotate the adjusting bolt -2- further once the end position has been reached or the components will be damaged.
-- Tighten the nut -1-.
-- Then check the camber value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK