Airbag Control Module -J234-, REMOVING AND INSTALLING: Installing

Install in reverse order of removal and note the following:

CAUTION:

Pyrotechnical components can deploy unintentionally.

There is a risk of injury.

- Discharge static electricity by briefly touching the door striker.

Make sure the connectors are pushed in all the way and that they engage audibly.

-- Follow all steps after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

CAUTION:

Risk of airbag deployment.

There is a risk of injury.

- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.

CAUTION:

There is a risk of malfunction when the control module is not activated correctly.

- Always adhere to the following procedure.

After every removal and installation of the Airbag Control Module - J234-, the Guided Function "Inertial sensor basic setting" must be performed.
If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when implementing the "0015 - Replace airbag control module" program.
If the Airbag Control Module -J234- is removed and then the same one is reinstalled, perform the "inertial sensor basic setting" as follows:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.