DTC Memory, Erasing And Ending Output
Indicated on display
| Rapid data transfer HELP Select function XX |
-- Press buttons 0 and 5 to select "Erase DTC Memory" function 05.
Indicated on display
| Rapid data transfer Q 05 - Erase DTC Memory |
-- Press Q button to confirm input.
If "DTC Memory is not erased" appears in the display:
| Attention! DTC Memory is not erased |
If the ignition was switched off, or if the vehicle was driven at over 20 km/h (13 mph), between the "Check DTC Memory" and "Erase DTC Memory" functions, then the DTC memory was not erased.
The DTC memory cannot be erased until after it has been checked.
Indicated on display
| Rapid data transfer DTC Memory is erased |
-- Press → button.
Indicated on display
| Rapid data transfer HELP Select function XX |
-- Press buttons 0 and 6 to select the "End Output" function 06.
Indicated on display
| Rapid data transfer Q 06 - End Output |
-- Press Q button to confirm input.
Indicated on display
| Rapid data transfer Q Output is ended! |
-- Switch ignition off.
-- Disconnect DLC connector from scan tool: VAG1551 .
-- Switch ignition on; ABS warning light -K47-, and ASR warning lamp if so equipped, must go out after a short time, about 2 seconds.
-- Carry out a road test during which the vehicle is driven at a speed of 60 km/h (38 mph) over a period of 30 seconds. When this is done, the ABS /EDL and ASR warning lamps and the brake warning light must not come on.