Oil Separator, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi A6 Quattro and 2021 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the cylinder ignition coils "3 and 4".Refer to IGNITION COILS, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and move the engine lifting eye -1- to the side.

Courtesy of AUDI OF AMERICA, LLC

-- If installed, disconnect the connector -1- for the Crankcase Pressure Sensor -G1068-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -1- and remove the hose from the EVAP Canister Purge Regulator Valve 1 -N80-.

Courtesy of AUDI OF AMERICA, LLC

-- Press the release buttons on both sides and remove the crankcase ventilation hose -2-.

-- Remove the bolts -arrows- and the oil separator.