New Connecting Rod, Separating
WARNING: This page is about a different car, the 2022 Audi A6 Quattro and 2021 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
A new connecting rod might not be separated all the way at the predetermined breaking point. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:
-- Mark the cylinder where the connecting rod is allocated to -item 4- OVERVIEW - PISTONS AND CONNECTING ROD => List Item: Connecting Rod.
-- Tension the connecting rod -1- under the dotted line in a vise equipped with aluminum protective pads.
- Clamp the connecting rod lightly to prevent damaging it.
-- Loosen both bolts -2- approximately five turns.
-- Carefully tap the connecting rod bearing cap -1- with a plastic hammer in the direction of -arrow- until it comes loose.