Overview - Engine Mount

WARNING: This page is about a different car, the 2022 Audi A6 Quattro and 2021 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

Subframe
Bolt
- 20 Nm
Bolt
- 10 Nm
Support Bearing
- Removing and Installing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
Bolt
- 55 Nm
Engine Support
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Heat Shield
Bolt
- 10 Nm
Bolt
- 55 Nm
Engine Mount
- With
  - Left Electrohydraulic Engine Mount Solenoid Valve -N144-
  - Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- The solenoid valve is integrated in the engine mount; cannot be replaced separately if faulty
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 90 Nm + 90°
- Replace after removing
Bolt
- 30 Nm

Support Bearing, Installation Position

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

The raised section -2- of the engine support must engage into the opening -1- on the support bearing.