Left Engine Support, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER .
-- Lift the clamp -3-, remove and free up the coolant hose.
-- Disconnect the connector -1- for the Engine Coolant Level Warning Switch -F66-.
-- Remove the bolt -4-, and push the coolant expansion tank -2- to the side.
-- Remove the upper bolts -2- for the engine support -1-. (Shown with the engine removed.)
-- Remove the left support bearing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
-- Remove the left engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
-- Remove the lower bolts -3- and the left engine support -1-.