Transmission Mount, Removing And Installing

WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Transmission Support, Removing with Transmission Mount

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tunnel crossmember. Refer to the appropriate Service Information .

-- Remove the bolts -arrows- and remove the transmission support with the transmission mount from the transmission.

Transmission Mount, Removing

Fig 1: Identifying Bolts, Nut, Transmission Mount And Transmission Support

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and remove the stop -2- for the transmission mount.

-- Remove the nut -4- and the bolt -5-, and remove the transmission mount -6- from the transmission support -3-.

Installing

Install in reverse order of removal and note the following:

Replace the bolts that were tightened with an additional turn after removing them.

-- First tighten the nut -4- and bolt -5- hand-tight.

-- Tighten the bolts -1- for the stop -2-.

-- Then tighten the nut -4- and bolt -5-.

Tightening Specifications

Refer to the appropriate Service Information .