Overview - Engine Mount

WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

Subframe
Bolt
- 20 Nm
Bolt
- 10 Nm
Support Bearing
- Removing and installing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
Bolt
- 55 Nm
Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Heat Shield
Bolt
- 10 Nm
Bolt
- 55 Nm
Engine Mount
- with
  - Left Electrohydraulic Engine Mount Solenoid Valve -N144-
  - Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 90 Nm + 90°
- Replace after removing.
Bolt
- 30 Nm

Support Bearing, Installation Position

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

The raised section -2- of the engine support must engage into the opening -1- on the support bearing.