Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .

-- Remove the engine cover. Refer to ENGINE COVER .

-- Disconnect the connector -2- and free up the wire.

Fig 1: Identifying Temperature Sensor Wire

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -1-.