Coolant Recirculation Pump -V50-, EMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- During installation, all heat shield boots must be installed at the same location.
-- Remove the coolant pipe for the transmission. Refer to TRANSMISSION COOLANT PIPES, REMOVING AND INSTALLING .
-- Remove the heat shield boot.
-- Disconnect the connector -4-.
-- Place a cloth underneath to catch any escaping coolant.
-- Lift the clamps -3 and 5- and remove the coolant hoses.
-- Remove the bolts -2- and remove the Coolant Recirculation Pump -V50- with the bracket.
-- If the pump should be replaced, remove the bolts -1- and remove the bracket.