After-Run Coolant Pump -V51-, EMOVING AND INSTALLING: Removing

• During installation, all heat shield boots must be installed at the same location.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Vehicles with a Particulate Filter:

Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamp -3-, remove and free up the coolant hose.

-- Disconnect the connector -1- for the Engine Coolant Level Warning Switch -F66-.

-- Remove the bolt -4-, and push the coolant expansion tank -2- to the side.

Continuation for All:

Courtesy of AUDI OF AMERICA, LLC

-- Unlock the catch in direction of -arrow A- and release in direction of -arrow B-, and remove the vacuum hose.

-- Remove the heat shield boot.

Fig 1: After-Run Coolant Pump -V51- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainer in direction of -arrow- and remove the After-Run Coolant Pump -V51- upward from the bracket.

-- Disconnect the connector -3-.

-- Place a cloth underneath to catch any escaping coolant.

-- Loosen the hose clamps -2- to clamp off the coolant hoses with the :3094  and remove them.

-- Remove the After-Run Coolant Pump -V51-.

-- If the pump should be replaced, remove the bolts -1- and remove the bracket.