Coolant Pump Toothed Belt, Removing And Installing: Removing

WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Required preliminary procedure descriptions. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .

Vibration Damper, Version 1:

Fig 1: Using T40263 & T40314

Courtesy of AUDI OF AMERICA, LLC

-- To do so counterhold the crankshaft on the vibration damper with the :T40263 , :T40314 and the 24 mm socket.

Vibration Damper, Version 2:

-- Counterhold the crankshaft at the vibration damper using either the :T40378 or :T40379 , depending on the version.

Continuation for All:

Fig 2: Removing Toothed Belt

Courtesy of AUDI OF AMERICA, LLC

TIP:

The drive wheel bolt has left-hand thread.

-- Counterhold the vibration damper and remove the bolt on the drive wheel -1- for the coolant pump and loosen three turns -arrow-. Use :VAG1410 and :T10360 .

-- Remove the toothed belt -2-.