Coolant Pump Toothed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the bolts that were tightened with an additional turn after removing them.
Note the toothed belt sprocket installation location ) OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT.

-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .

-- If removed, install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT .