Oil Pan Upper Section, Removing And Installing: Removing
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicles without high-voltage system: transmission removed. Refer to the appropriate service information .
- Vehicle with high-voltage system: engine is removed and is secured on the Engine and Transmission Holder. Refer to ENGINE, SECURING TO Engine and Transmission Holder .
Depending on the model, preliminary work may be required. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Remove the transmission side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
-- Remove the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .
-- Disconnect the connector -1- for the Oil Pressure Regulation Valve -N428-.
NOTE:
Ignore -2-
-- Remove the bolts -arrows-.
- First pry the oil pan upper section out on the transmission side. Proceed carefully when prying out.
Version 1 Oil Pan Upper Section:
-- Remove the bolts -1 and 14- and remove the oil pan upper section.
Version 2 Oil Pan Upper Section:
-- Remove the plugs on the three bolts.
-- Remove the bolts -1 and 18- and remove the oil pan upper section.