Overview - Engine Oil Cooler
WARNING: This page is about a different car, the 2021 Audi A6 Quattro, 2020 Audi A6 Quattro, and 2019 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Sub-Assembly Bracket
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Seal
- Always replace after removing.
- O-Rings
- Always replace after removing.
- Coat with engine oil
- Mechanical Switch Valve
- Replacing. Refer to MECHANICAL SWITCH VALVE, REMOVING AND INSTALLING .
- Engine Oil Cooler
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- See note. Refer to If large quantities of metal shavings or abraded material are found in the engine oil while servicing the engine, the oil passages must be carefully cleaned to prevent subsequent damage. Replace the additional oil spray jet, engine oil cooler and oil filter. .
- Seal
- Always replace after removing.
- Coat with coolant
- Connection
- Bolt
- 8 Nm + 45°
- Always replace after removing.