Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING

Removing

-- Remove the upper air duct pipe and pivot to the left side. Refer to UPPER AIR DUCT PIPE, REMOVING AND INSTALLING, 2.9L ENGINE .

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.

Install in reverse order of removal and note the following:

• Replace the O-ring after removing.

-- Install the upper air duct pipe. Refer to UPPER AIR DUCT PIPE, REMOVING AND INSTALLING, 2.9L ENGINE .

Tightening Specifications 

• Refer to OVERVIEW - CHARGE AIR SYSTEM, 2.9L ENGINE, BODY SIDE