Vacuum Pump, Removing And Installing, 2.9L/3.0L TFSI Engine: Installing
Install in reverse order of removal and note the following:
CAUTION:
Clean the bolts and nuts before reusing.
Replace the bolts and nuts if damaged.
Replace the self-locking bolts and nuts after removing
- Replace the seal after removal.
- Check the vacuum lines for damage before assembling and replace if necessary.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning in direction of -arrows-.
-- Install the vacuum line with the hose clamp -1- connected.
-- Install the lower air duct pipe. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .