Brake Master Cylinder, Removing And Installing, With Electromechanical Brake Master Cylinder: Removing
-- Remove the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .
-- To prevent brake fluid from escaping, place enough lint-free cloths in the area under the brake master cylinder.
CAUTION:
Risk of destroying the brake lines by bending.
- Never change the shape of the brake lines.
-- Remove the union bolts -2- for the brake lines and remove the brake lines from the brake master cylinder.
-- Immediately seal the open connection points with clean plugs from the Engine Bung Set:VAS6122 .
-- Remove the bolts -arrows-.
-- Disconnect and remove the brake master cylinder from the brake booster.