Brake Master Cylinder, Removing And Installing, With Electromechanical Brake Master Cylinder: Installing
Install in reverse order of removal and note the following:
Clean the bolts and nuts before reusing.
Replace the bolts and nuts if damaged.
Replace the self-locking bolts and nuts after removing
- Replace the seal after removal.
- Do not let any brake fluid run into the brake booster.
-- When inserting the brake master cylinder, make sure the pushrod is seated correctly in the brake booster.
-- If necessary, have a second technician press the brake pedal downward slightly. This allows the brake master cylinder to be guided into the pushrod more easily.
-- Install the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .
-- Fill the brake fluid reservoir up to the "MIN" mark.
-- Remove all cloths from the vehicle that were previously placed down.
-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .
Faulty brakes increase the risk of an accident.
- Make sure the brakes are working correctly before driving the vehicle for the first time.