Brake Booster, Removing And Installing, Electromechanical Brake Booster: Removing
-- Switch off the ignition.
-- Disconnect the brake pedal from the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .
-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .
-- Remove the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .
-- Disconnect the connectors -1-.
Leaking brake fluid increases the risk of injury.
Risk of skin irritation and injury.
- Wear safety gloves.
-- Remove the bolts -2 and 3-.
-- To protect against escaping brake fluid, place enough lint-free cloths in the area below the brake booster.
-- Remove the union bolts -arrows- for the brake lines, then remove the brake lines from the brake master cylinder and move them slightly to the side.
Risk of destroying the brake lines by bending.
- Never change the shape of the brake lines.
-- Immediately seal the open connection points with clean plugs from the Engine Bung Set:VAS6122 .
-- Remove the windshield wiper motor. Refer to WINDSHIELD WIPER MOTOR -V-, REMOVING AND INSTALLING .
-- Remove the brake booster with the brake master cylinder.