Latch Release Lever, Removing And Installing
Removing
-- Pull the clip -2- out of the release lever -1- slightly -arrow A- using a small screwdriver.
-- Pull the operating lever toward the rear -arrow B- to release the hood and hold it in this position.
-- At the same time, pull the release lever so it is level with the center of the vehicle and out of its mount -arrow C-.
Installing
Install in reverse order of removal and note the following:
-- Slide the clip all the way into the release lever.
-- Press the release lever onto the mount in the mounting bracket and engage it.
-- Push back the operating lever clamp.