Side Spoiler, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- The vehicle and the bracket must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the adhesive surfaces using the Cleaning Solution :D 009 401 04 .
-- Fold back the ends of the protective film, or attach a pulling aid -4 and 6- to the protective film.
-- Position the side spoiler -3- at the top of the rear lid with the clip -5- and push it over the stop ridge -2- at the bottom to the stop on the rear lid -1-.
-- Remove the protective film from the pulling aid and from the adhesive tape.
-- Push the entire length of the side spoiler on using the :3356 .
- Vehicle resting time is at least 30 minutes at room temperature.