Tires, Changing, Vehicles With Tire Pressure Monitoring System

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi S5, 2022 Audi A5 Quattro, 2021 Audi S5, 2021 Audi A5 Quattro, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Dismounting

Fig 1: Dismounting Tire

Courtesy of AUDI OF AMERICA, LLC

The metal valve and the tire pressure sensor can be used again.

-- Release the tire air by unscrewing the nickel-plated valve insert.

-- Roll or press the tire off.

-- When using pressure paddles, first separate tires from side opposite of valve.

NOTE:

Do not use a bead breaker in the shaded area -a-.

-- Position the mounting head near the valves so the tire iron can be positioned approximately 30° -b- next to the valve.

-- Then remove tire in valve area first.

-- Visually inspect for any loosened or damaged parts.

NOTE:

If there are any loosened threaded connections, replace the entire valve unit.

Replace a damaged tire pressure monitoring sensor.

Installing

Fig 2: Identifying Mounting Tire

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not use a bead breaker in the valve area.

-- Position the tire pressure monitoring sensor approximately 180° opposite the mounting head.

-- Press the tire into the bed approximately 90° in front of mounting head -arrow-.

-- Mount the tire.

-- Install a new valve insert.

-- Fill the tires and install the plastic cap.

-- Balance the tires.