Steering Angle Sensor -G85- BASIC SETTING
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi S5, 2022 Audi A5 Quattro, 2021 Audi S5, 2021 Audi A5 Quattro, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Steering Wheel Scales: VAS6458
This basic setting should be selected after the following actions:
- Settings to the suspension were changed.
- The Steering Column Electronics Control Module -J527- was replaced.
- The Active Steering Control Module -J792- was replaced,
- The steering column was replaced.
Procedure
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Electrical system
- 0001 - OBD-capable system
- 0016 - Steering column electronics control module J527
- 0016 - Steering column electronics control module functions
- 0016 - Steering Angle Sensor G85
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.