Rear Axle Toe, Adjusting
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi S5, 2022 Audi A5 Quattro, 2021 Audi S5, 2021 Audi A5 Quattro, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Fine tooth ratchet, commercially available
- 21 mm internal multi-point socket, commercially available
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and Parts Information prior to starting procedure.
Mandatory Replacement Parts
- Nut - for Adjusting Bolt
Procedure
-- Remove the nut -1- from the threaded connection for the tie rod/subframe, and install the new nut all the way.
-- Adjust the toe by turning the eccentric bolt -2-.
NOTE:
To turn the eccentric bolt, turn the hex head at the >>top of the bolt<<.
- Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES, SEDAN / AVANT .
NOTE:
The maximum adjustment range is 90° to left or right of center position.
The geometric drive axle is automatically changed when individual toe settings are changed.
-- Tighten the nut and check the toe value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES, SEDAN / AVANT .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK