LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> RS 5 >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Pedestrian Protection >> Overview - Pedestrian Protection

Overview - Pedestrian Protection

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi A5 Quattro, 2021 Audi S5, 2021 Audi RS 5, and 2021 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Pedestrian Protection
GWWA69-11278Courtesy of AUDI OF AMERICA, LLC
  1. Pedestrian Protection Crash Sensor 2
    • Driver Side Pedestrian Protection Crash Sensor 2 -G851-
    • Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
    • Unit with pressure hose
    • Component location: in the molded foam part on the impact member
    • Must be replaced when
      • The molded foam part is visibly damaged.
      • The impact member is visibly deformed.
      • The bumper cover is deformed.
      • The pressure hose is damaged.
    • Place the pressure hose in the groove on the molded foam part.
    • Insert the pressure hose in the center of the molded foam part, the projecting end is the same on both the left and right side.
    • Do not kink or squeeze the pressure hose.
    • Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR, REMOVING AND INSTALLING .
  2. Front Passenger Side Pedestrian Protection Crash Sensor -G571-
  3. Bolt
    • 8 Nm
  4. Pedestrian Protection Center Crash Sensor -G693-
  5. Bolt
    • 8 Nm
  6. Pedestrian Protection Trigger 2 -G599-
  7. Clip
  8. Seal
  9. Seal
  10. Clip
  11. Pedestrian Protection Trigger 1 -G598-
  12. Bolt
    • 8 Nm
  13. Driver Side Pedestrian Protection Crash Sensor -G570-
scientia non olet · About LEMON Manuals