Electronic Damping Basic Setting

Special tools and workshop equipment required 

• Vehicle Diagnostic Tester

Select this basic setting for the following operations:

• The coupling rod on a level control system sensor was separated from the control arm.
• The threaded connection for a level control system sensor was loosened.
• A level control system sensor was removed and installed.
• A front or rear shock absorber was replaced.
• If the Electronic Damping Control Module -J250- was removed or installed.

-- After performing the respective procedures, select the "Basic Setting" program. Refer to DIAGNOSTIC ENTRIES .

-- Follow the instructions in the Vehicle Diagnostic Tester display.

The following procedures must be performed after a basic setting:

• Adjust the headlamps. Refer to HEADLAMP, ADJUSTING .
• Driver Assistance Systems Front Camera, Calibrating. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .