Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Controller Housing

Courtesy of AUDI

Install in the reverse order of removal while noting the following:

Replace the seal after removal.

-- Install the coolant pump -1- and toothed belt.

-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.

-- Tighten the coolant pump bolts. Refer to Figure.

-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.

Fig 2: Identifying Coolant Pump

Courtesy of AUDI

There are additional procedures depending on the model. Refer to COOLANT PUMP, REMOVING AND INSTALLING .