Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Observe the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Vehicles with a Particulate Filter

-- Remove the particulate filter. Refer to PARTICULATE FILTER, REMOVING AND INSTALLING .

AWD Vehicles without Particulate Filter.

-- Remove the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

FWD Vehicles without Particulate Filter.

Courtesy of AUDI

-- Loosen the clamping sleeve -arrow-.

-- Remove the bolts -arrows-.

Fig 1: Exhaust System Bracket

Courtesy of AUDI

-- Press the catalytic converter together with the front exhaust pipe to the side.

Continuation for all vehicles

Courtesy of AUDI

-- Disconnect the connector -4-.

-- Loosen the lock nut -2- a quarter turn, to do so counterhold on the control rod hex fitting -arrow-.

-- Remove the control rod from the operating lever -1- at the same time do not turn the lock nut.

-- Remove the bolts -3- and then the Charge Air Pressure Actuator -V465-.