Part II
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
- Cylinder Head
- Do not rework the upper sealing surface
- Only replace the cylinder head and cylinder head cover together
- O-Ring
- Check for damage
- Not available separately, included in the delivery package -item 3- Part II List Item:Cam Adjustment Actuator
- coat with engine oil
- Cam Adjustment Actuator
- Cam Adjustment Actuator 1 -F366-
- Cam Adjustment Actuator 2 -F367-
- Cam Adjustment Actuator 3 -F368-
- Cam Adjustment Actuator 4 -F369-
- Cam Adjustment Actuator 5 -F370-
- Cam Adjustment Actuator 6 -F371-
- Cam Adjustment Actuator 7 -F372-
- Cam Adjustment Actuator 8 -F373-
- Removing and installing. Refer to CAM ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .
- Bring into the installation position. Refer to Installing The cam adjustment actuator pin must be brought into the installation position. .
- Bolt
- 5 Nm
- Ball Pin
- In the existing threads: 9 Nm
- In the new tapping threads: 11 Nm
- For the engine cover
- thread cutting
- Instructions for tightening the self-tapping bolts. Refer to BOLTS AND NUTS .
- O-Ring
- Replace if damaged
- Coat with engine oil
- Plugs
- O-Ring
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Camshaft Position Sensor 3 -G300-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Vacuum Pump
- Overview. Refer to OVERVIEW - VACUUM PUMP .
- Bolt
- Tightening specification. Refer to OVERVIEW - VACUUM PUMP .
- Seal
- Replace if damaged
- O-Ring
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- In the existing threads: 9 Nm
- In the new tapping threads: 11 Nm
- Thread cutting
- Instructions for tightening the self-tapping bolts. Refer to BOLTS AND NUTS .
- Bracket
- For the EVAP Canister Purge Regulator Valve 1 -N80-