Bearing Bracket, Removing And Installing, Engine With Two Camshaft Adjusters: Installing
-- Install the bolts -arrows- and tighten them. Tightening specification. Refer to -item 4- OVERVIEW - CYLINDER HEAD List Item:Bolt.
-- Coat the holes -arrows- with engine oil.
-- Check if the adapter sleeve -1- is installed.
- If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.
- If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. A shorter bolt -2- must also be used for this hole. Refer to the Parts Information for the bolt.
- Carefully connect the bearing bracket without tilting - risk of damage.
-- Mount the bearing bracket and the bolts -arrows- hand-tight.
-- Remove the Tensioner Locking Tool:T40267 .
-- Tighten the bearing bracket bolts. Refer to Figure.
Installation is performed in reverse order of removal, noting the following:
-- Install the upper timing chain cover. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING, ENGINE WITH TWO CAMSHAFT ADJUSTERS .
There may be additional procedures depending on the model. Refer to Chain Drive ; Bearing Bracket, Removing and Installing.
After Removing or Replacing the Chain Drive Components the Adaptation Values for the Chain Length Must Be Adapted Again.
-- Connect the Vehicle Diagnostic Tester .
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01 - OBD-capable systems .
- 01 - Engine Electronics
- 01 - Engine electronics, functions
- 01 - Chain length diagnostic adaptation