Engine Support, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Lift the engine on the right to the dimension -a- using the Engine Support Bridge - Spindle:10 - 222 A/11 -item 1-.

Fig 1: Identifying Engine Support Bridge - Spindle 10 - 222 A /11

Courtesy of AUDI

Dimension -a- = approximately 30 mm.

-- Remove the bolts -1, 2 and 3- and the engine support.

Fig 2: Engine Support - Tightening Sequence

Courtesy of AUDI