LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> Q3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Cooling System (4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Ea 888 Generation III)) (DSNA)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Front Coolant Pipe, Removing And Installing >> Removing

Front Coolant Pipe, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
GWWA23-10658Courtesy of AUDI

-- Remove the bolts -1 and 3-.

-- Release the catch -arrow- and remove the cover -2-.

-- Free up the coolant hose -2-.

GWWA23-10659Courtesy of AUDI

-- Open the catches -arrows- and remove the upper air duct -1-.

-- Remove the bolt -arrow- on the left and right.

GWWA23-10689Courtesy of AUDI

-- Unclip and remove the lower section -1- of the air duct.

-- Place a cloth underneath to catch any escaping coolant.

Fig 1: Identifying Coolant Hose Clamps
GWWA19-11612Courtesy of AUDI

-- Disconnect the coolant hoses -1 and 2- with Hose Clamps - Up To 25mm:3094  .

-- Loosen the clamps and remove the coolant hoses.

-- Remove the bolts -arrows- and the front coolant pipe.