Input Shaft Seal, Replacing: Notes
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Press Piece - 37mm:VW416B
- Puller - Seal Lever:VW681
- Counterhold - Crankshaft Sprocket:3415
- Seal Installer - Shaft Seal Ring:T10019
- Tensioning Strap:T10038
- Counterhold - Kit - Multiple Use:T10172A with Counterhold - Kit - Adapter 5:T10172/5
- Torque Wrench 1601:VAG1601
- Used Oil Collection and Extraction Unit:SMN372500
- Puller - Kukko 3 Jaw - 100x100mm:12/1
- Locking Compound:D 000 600
- Bolt M10 x 25
- Socket Hex Head Screw M8 x 15
- Do not bend the driveshaft, only store and move when fully extended.
- Never let the driveshaft "just hang" during removal. Always support it.
- Always remove or install the driveshaft horizontally with respect to the centering pin.