Rear Flexible Disc, Removing And Installing: Installing

Install in reverse order of removal. At the same time note the following:

• Install all marked parts in their original position.
• Replace the bolts that were tightened with an additional turn.

-- Attach to the driveshaft to the rear final drive making sure the marks -arrows- are lined up.

Fig 1: Aligning Markings On Driveshaft At Flange Of Haldex Clutch

Courtesy of AUDI

-- Tighten the bolts for attaching the driveshaft flexible disc to the bevel box and to the rear final drive.

-- Tighten the bolts -2 and 3- for the pendulum support.

Fig 2: Engine Support Component Location

Courtesy of AUDI

-- Align the intermediate bearing in the oblong holes so that neither the driveshaft nor the intermediate bearing are under stress.

-- Tighten the bolts -arrows-.

Fig 3: Locating Center Bracket Screws

Courtesy of AUDI