Overview - Driveshaft, Bolts On Transmission Side
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Do not perform any repair work on the driveshaft.
- Bolt
- 20 Nm + 90°
- Replace after removing
- Driveshaft
- Cannot be separated at the joint.
- Removing and installing. Refer to DRIVESHAFT, REMOVING AND INSTALLING .
- Bolt
- 50 Nm + 90°
- Replace after removing
- For the front flexible disc on the driveshaft
- Bevel Box
- Front Flexible Disc
- Installation position: the open side of the heat shield faces the transmission
- Bolt
- 50 Nm + 90°
- Replace after removing
- For flexible disc to bevel gear
- Double Bolt
- 40 Nm
- Heat Shield
- Bolt
- 20 Nm
- Intermediate Bearing
- Align free of tension
- Bolt
- 50 Nm + 90°
- Replace after removing
- For the rear flexible disc on the driveshaft
- Rear Final Drive
- Removing and installing. Refer to OVERVIEW - FINAL DRIVE .
- Flexible Disc with Vibration Damper
- Heat shield faces the driveshaft
- Bolt
- 50 Nm + 90°
- Replace after removing
- For flexible disc to final drive