Oil Level, Checking
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Shop Crane - Drip Tray:VAS6208
- Pay attention. Refer to SAFETY PRECAUTIONS DURING ROAD TEST WITH TESTING EQUIPMENT .
Test Requirements
- The oil temperature must be 20 to 40 °C (68 to 104 °F).
- The oil temperature can be reached by driving the vehicle for a while.
- The vehicle must be level.
- Final drive must be in the installation position to check oil level.
-- Read the oil temperature using the Vehicle Diagnostic Tester in Guided Functions .
Enter "Guided Fault Finding" :
-- Switch the ignition on.
-- Touch the "Guided Functions" field/button on the screen.
-- Select one after another on the tester:
- Brand
- Type
- Model year
- Variant
- Engine codes
- Confirm the information entered.
- 22 - AWD electronics
- 22 - Read the measured values block
- Clutch Temperature
-- Read the oil temperature.
- The oil temperature must be 20 to 40 °C (68 °F to 104 °F).
Check the Oil Level.
-- Place the :VAS6208 under the final drive.
-- Remove the oil level inspection plug -2-.
The Oil Level Is Correct if the All Wheel Drive Clutch Is Filled to the Lower Edge of the Oil Filler Hole or up to 3 Mm below the Oil Filler Hole.
-- Fill the oil for the all wheel drive clutch if necessary. Refer to Fill the All Wheel Drive Clutch Oil .
Tightening specifications: