Removing the
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Removal is performed in the reverse order. Note the following:
-- Always only remove one locating pin and replace it with a new bolt.
CAUTION:
Improper handling increases the risk of damaging the threads in the vehicle body.
- Never use an impact wrench to loosen or tighten.
- Position the bolts by hand only and screw in the first threads.
-- A road test must be performed after completing repairs. If the steering wheel is crooked, the wheels must be aligned. Refer to AXLE ALIGNMENT .
Tightening Specifications
- Refer to OVERVIEW - SUBFRAME
- Refer to OVERVIEW - NOISE INSULATION .
- Refer to OVERVIEW - UNDERBODY TRIM PANELS .