Overview - Intake Manifold
- Bolt
- 20 Nm
- Intake Manifold Support
- Nut
- 10 Nm
- Bonded Rubber Bushing
- 5 Nm
- Bolt
- 7 Nm
- Throttle Valve Control Module -J338- or Throttle Valve Control Module -GX3-
- Designation in the wiring diagram depends on the model
- With EPC Throttle Drive -G186-, EPC Throttle Drive Angle Sensor 1 -G187- and EPC Throttle Drive Angle Sensor 2 -G188-
- Removing and Installing. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING .
- Perform the adaptation after replacing using the Vehicle Diagnostic Tester
- Cleaning. Refer to THROTTLE VALVE CONTROL MODULE, CLEANING .
- Seal
- Replace after removing
- Intake Manifold
- Removing and Installing. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Intake Manifold Runner Position Sensor -G336-
- Ball Pin
- 5 Nm
- For the engine cover
- O-Ring
- Replace if damaged
- Bolt
- 1.5 Nm
- Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71- or Intake Manifold Sensor -GX9-
- Designation in the wiring diagram depends on the model
- Removing and Installing. Refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Tighten diagonally in multiple steps
- Ball Pin
- 5 Nm
- For the engine cover
- Bracket
- For the connector
- For the versions with MPI injection
- Bolt
- 5 Nm
- Bolt
- 9 Nm
- Tighten diagonally in multiple steps
- Seal
- Replace after removing
- Vacuum Hose
- From the vacuum pump
- Intake Manifold Runner Control Valve -N316-
- Removing and Installing. Refer to Intake Manifold Runner Control Valve -N316-, REMOVING AND INSTALLING .
- Vacuum Hose
- Bracket
- For the connectors
- Bolt
- 5 Nm