Overview - Drive Plate

Fig 1: Exploded View Of Drive Plate

Courtesy of AUDI OF AMERICA, LLC

Cylinder Block
Transmission Side Sealing Flange
- With gasket
- Do not apply oil to the seal.
- Replacing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Before installing, remove oil residue from crankshaft journal with a clean cloth.
- The guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft journal.
Bolt
- Tightening specification and sequence. Refer to Figure.
Intermediate Plate
- Be careful not to damage or bend when installing
- Installing. Refer to Figure.
Alignment Sleeve
Bolt
- 60 Nm +90°
- Replace after removing
Washer
Drive Plate
- Removing and Installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Only possible to install in one position - holes are offset -
- The >>collar<< faces the cylinder block
Shim
- Usage. Refer to Installing .